|
|
| |
|
 This system includes delivery
system inside a small metal box, which can be positioned near the sample using included 1 ft. rod. Comes with
X-block that fits to standard 0.5 in. stands. 2-Channel controller allows to switch
channels manually, by analog signals, through software commands, or by TTL signals.
The controller can also operate valves in SLAVE mode (when one closes,
another opens automatically). When lines are closed, the setup works like a regular pipette holder to allow seal
formation. After obtaining whole-cell configuration, one channel can be open to allow solution withdrawing from a small
reservoir system (included). Since the end of filament is positioned near the pipette tip, perfusion of
intracellular content occurs (only few microlitters are needed to replace the content of the pipette tip). If wider
pipettes are used, multiple filaments can be positioned inside the pipette to
exchange two or more solutions (see schematics). Since flow units are inside metal box and are connected to the controller through shielded
cables, there is no electrical noise during switching.
Click on catalog numbers below to purchase online.
Download PDF manual.
Download PDF catalog.
|
|
Bioscience Tools
ph: 1-877-853-9755
ph: 1-619-582-1597 (from outside USA)
fax: 1-619-582-0919
email: info@biosciencetools.com
|
PRICES AND OPTIONS |
IP1 |
$4,800 |
Intracellular Perfusion System
|
IP1-A |
$2,160 |
1-Channel, Intracellular Perfusion System
|
|
|
)
){kind=link}